How to Hang a Dartboard Cabinet? | Studs, Height & Leveling

Guide / By

Hang a dartboard cabinet by anchoring it into wall studs with its center at 5’8″ from the floor, keeping it level and plumb.

Hanging a dartboard cabinet looks straightforward until you lift the heavy assembled unit and realize a drywall anchor won’t hold it. The key is finding the studs, marking the right height, and leveling the cabinet before tightening the screws.

Finding The Right Wall And Height

Choose a spot with roughly 10 feet of open space in front of the board, and set the toe-line at 7′ 9 1/4″ from the face of the dartboard, per one bristle dartboard cabinet set manual. The regulation bullseye height is 5 feet 8 inches (68 inches) from the floor—the center of the dartboard, not the top of the cabinet. Mark the wall at this height, then use a stud finder to locate framing behind it.

Exact spacing varies by model, but anchoring into solid wood is the priority.

Securing The Cabinet To The Wall

These cabinets are heavy, so mounting must go beyond drywall alone. For concrete or solid walls, one manual instructs using wall anchors rather than wood screws. For standard drywall construction, drive screws directly into studs.

Drill pilot holes before driving screws to prevent wood splitting. Hold the cabinet at your marked height, check it with a level, and partially drive the top two screws—leaving them loose for adjustment. Tighten the bottom screws fully, then finish the top.

Mounting The Dartboard Inside The Cabinet

Attach the included wall-mounting bracket to the dartboard’s back if not pre-installed. Center the board in the opening, hang it on the bracket, and rotate it so the 20 segment is at the top.

Confirm the cabinet is perpendicular to the floor. A crooked cabinet affects the board’s angle and play.

Common Mounting Mistakes To Avoid

  • Mounting into drywall only. A loaded cabinet is too heavy for drywall anchors. Find the studs, or the cabinet will pull loose.
  • Misreading the height. The 5’8″ mark is the bullseye center, not the top edge of the cabinet.
  • Skipping the level. Check both side-to-side and front-to-back before final tightening.
  • Ignoring the model’s hardware. Some cabinets have hanging brackets, others predrilled holes, some require your own anchors. Read the manual and use what’s in the box.

Comparing models? Our roundup of the best dartboards with cabinets covers top-rated sets.

FAQs

Do I need to find a wall stud to hang a dartboard cabinet?

Yes, for most homes. The assembled cabinet is too heavy for drywall anchors. Use a stud finder and drive included screws into wood framing. For concrete or brick, use wall anchors per the manual.

Why does my dartboard keep falling off the bracket?

If the bracket shifts, check its screws are seated firmly in studs, not hollow drywall.

Can two people hang a dartboard cabinet more easily?

Yes. One holds the cabinet level while the other drives pilot holes and screws, making it easier to confirm a flush, plumb fit before final tightening.

References & Sources

Please use a real email you check. If it's fake or mistyped, your message won't reach us and we can't reply — wrong addresses are rejected automatically.